U0167 Lost Communication With Intrusion Transceiver Control Module (In ORC/SRS Module)

U0167 code - When monitored this DTC with the ignition on, battery voltage between 10 and 16 volts, ignition Off Draw (IOD) fused installed, Tottaly Integrated Power Module (TIPM) is configured correctly. Set condition this DTC if the Occupant Restraint Controller (ORC) BUS messages not received from the Intrusion Transceiver Module (ITM) for approximately two to five seconds.

U0167


Possible causes U0167 code:

- CAN C Bus (+) circuit shorted to voltage

- CAN C Bus (-) circuit shorted to ground

- DTCa related to battery voltage, ignition, or VIN messages

- TIPM not configured correctly

- Intrusion Transceiver Module power and ground

- Intrusion Transceiver Module (ITM)

- Occupant Restraint Controller (ORC)

Diagnostic test U0167 code

Verify diagnostic trouble code is active

Make sure the IOD fuse is installed and battery voltage is between 10 and 16 volts before proceeding. Turn the ignition on, with the scan tool read ORC DTCs.

Is the U0167 code active?

Yes, refer to DTC in the site TIPM DTC and perform the U0167 code diagnostic procedure.

No, refer to Non DTC diagnostic in the site and perform the stored lost communication DTCs diagnostic procedure.

0 Response to "U0167 Lost Communication With Intrusion Transceiver Control Module (In ORC/SRS Module)"

Post a Comment

Sponsored links