U1409 Implausible left front wheel speed signal received

U1409 code - Theory of operation this DTC the messages sent on the Can bus are distinguished by an identifier (ID). Each Can id is defined to contain a certain number of bytes. The transmission control module (TCM) verifies that it has received the proper number of bytes for each id. 

When monitored continuously with the ignition on, one valid Can id received at least once, and no U0002 can bus off performance DTC present.

Set condition when the TCM detect an incorrect can id from the ABS control module.

Possible causes U1409 code:

- TIPM Can Bus DTCs present 

- ABS control module DTCs present

- Transmission control module

Diagnostic test U1409 code

Step 1. Check for TIPM Can bus DTCs

With the scan tool, read TIPM DTCs.

Are there any TIPM CAN BUS DTCs present?

Yes, perform NAG1 Transmission Verification Test.

No, go to step 2.

Step 2. Check If ABS DTCs are present 

With the scan tool, read ABS DTCs.

Are there any ABS DTCs present ?

Yes, refer to 28 DTC based diagnostics/module, antilock (ABS) diagnosis and testing and perform the diagnostics for the DTCs in the ABS module. Perform NAG1 transmission verification test refer to 28 DTC based diagnostics/module, transmission control (TCM) standard procedure.

No, using the schematics as a guide, check the transmission control module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the TCM in accordance with the service information. Perform NAG1 Transmission Verification Test.

Share this post