U1414 Implausible/Missing Ecu Configuration Data

Note: This DTC detected in the ORC Module

U1414 code - When monitored this DTC with the ignition on, The Occupant Restrain Controller (ORC) on board diagnostics continuously monitor the CAN Bus message from the TIPM containing the ORC configuration data. Set condition this DTC will set if the ORC configuration Bus Message is invalid or missing.

Possible causes U1414 code:

- Occupant Restraint Controller (ORC)

- Totally Integrated Power Module (TIPM)

Diagnostic test U1414 code

Step 1.Verify Totally Integrated Power Modul (TIPM) Operation

Turn the ignition on, with the scan tool, read TIPM DTC.

Does the scan tool display any TIPM DTC?

Yes, refer to Totally Integrated Power Module (TIPM) DTC group and perform the active DTC diagnostic procedures in the TIPM before continuing with ORC diagnostics.

No, go to step 2.

Step 2. Check Operation Of The Occupant Restraint Controller

Turn the ignition off, disconect the 12-volt battery and wait two minutes before proceeding. If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these intructions may result in possible serious or fatal injury.

Replace the Occupant Restraint Controller in a accordance with the service information.

Turn the ignition on, then reconnect the 12-volt battery and wait two minutes before proceeding. Connect the scan tool to the Data Link Connector - use the most current software available. Wait one minute, and read active codes and if there are none present read the stored codes.

Did the active U1414-Implausible/Missing Ecu Configuration Data DTC return?

Yes, replace the Totally integrade Power Module (TIPM).

No, repair is complete.

Share this post