C1044 Right Rear Tone Wheel Performance

C1044 Right Rear Tone Wheel Performance - When the Antilock Brake System (ABS) Module detects periodic drops of a wheel speed sensor (WSS) signal.

C1043 Left Rear Tone Wheel Performance

Possible Causes

  • Dirty tone wheel/sensor.
  • Improper right front tire pressure/mismatched tires.
  • Axle shaft fastener hardware.
  • Right rear tone wheel/bearing damage.

Diagnose DTC C1044 Right Rear Tone Wheel Performance

Step 1. Check for a DTC
This DTC must be active for the result of this test to be valid.
Turn the igntion on, with the scan tool, read DTC. Record and freeze frame information. With the scan tool, erase DTC. Cycle the ignition switch off then on.

Caution: Make sure braking capability is available before road testing.

Test drive the vehicle in a straight line to 40 km/h (25mph).
Vehicle must be driven above 40 Km/h (25 mph) for set conditions to be met.
With the scan tool, read DTC.

Does the scan tool display C1044 RIGHT REAR TONE WHEEL PERFORMANCE?

YES, go to step 3.
NO, go to step 2.

Step 2. Check wheel speed sensor signals
Turn the ignition on, with the scan tool, monitor and graph All the WSS speeds and compare graph while an assistant drives the vehicle. If graph shows periodic dropouts pay close attention to the tone wheel.
Slowly accelerate as staright as possible from a stop to 40 km/h (25 mph).

Is the Right rear WSS speed showing 0 km/h (0 mph) or not matching other wheels or showing erratic behavior?

YES, go to step 3
NO, Perform the ABS Verification Test.

Step 3. Check for improper right rear tire pressure/mismatched tires
Turn the ignition off, check and adjust the right rear tire pressure. Check and adjust all other tire pressures, inspect for mismatched tires on vehicle.

Is the right rear improperly inflated or mismatched tires on vehicle?

YES, repair as necessary.
NO, go to step 4.

Step 4. Check axle shaft fastener hardware for looseness
Inspect the axle shaft fastener for looseness, and not properly fastened. Tighten fastener to proper specification as required.

Was the axle shaft fastener loose?

YES, repair as necessary.
NO, go to step 5.

Step 5. Check the right rear tone wheel/bearing for damage
Check the tone wheel teeth for missing teeth, cracks, or looseness. Teeth should be perfectly square, not bent, or nicked.
Check the right rear tone wheel/bearing for damage, check the left rear tone wheel for dirt.

Was the tone wheel dirty?

YES, clean tone wheel and sensor. Clear codes and retest.
NO, replace the Right rear tone wheel/bearing.

2 Responses to "C1044 Right Rear Tone Wheel Performance"

  1. Good informative article on Rear Tone Wheel brake performance and very good explanation steps by step to diagnose it.

    ReplyDelete

Sponsored links